User's Manual

Changing the Lubrication Canister
3A0416C 19
To begin the discharge:
Plug power cable into lubricator (FIG. 8).
.
During Operation:
• Carry out regular performance checks.
Check for possible leakages and the status
of the lubricator.
• Regularly monitor the fill-level of the trans-
parent lubrication canister.
Changing the Lubrication
Canister
When the red and green LED light up at the
same time, the lubrication canister is empty
and should be replaced.
Removing Lubrication Canister
1. Unplug cable from lubricator (F
IG. 9).
2. To disconnect adapter from lubrication
point, follow pressure relief procedure
provided on page 6.
3. Unscrew and com-
pletely remove adapter
(B) from the lubricator.
Adapter will be reused.
4. Unscrew cover from
drive unit.
5. Remove drive unit from
the lubrication control.
FIG. 8
NOTICE
The drive unit and circuit board must always
be protected from moisture to prevent dam-
aging these components. Always change the
lubrication canister in a dry place.
FIG. 9
B