User's Manual

Repair
74 3A0294G
Repair
The shot dispense kits do not include any repairable
parts. They include only replacement parts. Therefore,
see the Installation section that is specific to your kit for
instructions on replacing kit parts. Also use the Electri-
cal Schematics section, page 75, as a reference.
For system specific repair procedures, refer to your Sup-
ply Systems Repair-Parts manual or pump package
instructions-parts manual.
Replace Display
NOTE: Order Kit 262539 for replacement.
1. Disconnect power.
2. Pull display out of bracket clips to remove it.
3. Disconnect both CAN cables.
4. Replace with new display. Reconnect both CAN
cables.
5. Load the correct display software for the system.
Follow the steps in Upgrade Display Software on
page 72.
NOTICE
To avoid damaging circuit board, wear a grounding
strap.