User's Manual

Shutdown
70 3A0294G
Shutdown
1. Follow the Pressure Relief Procedure on page 51.
2. Remove the spray tip and tip guard from gun or
remove the nozzle from the dispense valve.
3. Place siphon tube in grounded metal pail containing
cleaning fluid.
4. Turn the regulator adjustment knob counterclock-
wise to the lowest possible fluid pressure.
5. Change to manual mode in the run screen. See
Change Operation Mode, page 62.
6. Hold a metal part of the gun/valve firmly to the side
of a grounded metal pail, and press or step
on the foot switch (purchase separately) until clean
solvent dispenses.
7. Follow the Pressure Relief Procedure on page 51,
again.
NOTICE
Never leave water or water-base material in pump
overnight. If you are pumping water-base material,
flush with water first, then with a rust inhibitor, such
as mineral spirits solvent (or white spirit). Relieve
pressure, but leave rust inhibitor in pump to protect
parts from corrosion.
FIG. 104