User's Manual

Set System Parameters
3A0294G 53
Set System Parameters
NOTE: Refer to Appendix B - Tips, page 102, for setup
guidelines and tips.
Set Units and Specific Gravity
1. Navigate to setup screen 1.
2. Press to access fields to make changes.
3. Press to navigate to the units of mea-
sure fields.
4. Press to open the first drop-down box. Press
to select the desired units.
5. Press to save selection.
6. Press to navigate to the next drop-down box,
and perform the same two steps.
7. Press to navigate to the specific gravity (SG)
field.
NOTE: If the specific gravity is unknown, use the cali-
bration routine to enter it automatically. See Calibrate
on page 60 for calibration instructions.
8. Press and to increment or decre-
ment to the specific gravity of the material being dis-
pensed.
9. Press to save the selection.
10. Press to exit edit mode.