User's Manual

Installation

42 3A0294G

9. Route all cables out the top of the electrical enclo-

sure. Make sure there is enough slack to extend ram

to full height. Secure cables to the air hose using zip

ties. Tighten all zip ties and then cut off the excess.

10. Bundle the excess cable length and zip tie them

close to the electronics bracket (1) so that they will

fit under the electronics subassembly cover (4).

11. Install the electronics subassembly cover. Install the

back cover first and hand tighten the screws to

secure. Then install the cover and hand tighten the

screws to secure.

12. Install the power supply cord (12).

13. Open the air shutoff valves on the air control assem-

bly.

FIG. 78: Install Cover

FIG. 79: Install Power Supply Cord

Install Power

Supply Cord

r_262373_3A0294_42a