User's Manual

Installation

38 3A0294G

c. Loosely install the air valve assembly (3)

Remove air pressure gauge if necessary.

Grease the o-ring included with the air valve

assembly. Install the o-ring and then finish

installing the air valve assembly. Secure with the

two screws that are included with the air valve

assembly.

d. Install the new air motor slider valve label that is

included with the air valve assembly.

e. If removed, coat the gauge fitting and elbow fit-

ting with PTFE tape, and then reinstall. Use a

wrench to tighten.

f. Install the fitting and air hose on the back of the

new air valve assembly. Use two wrenches to

tighten.

5. Install the linear sensor (17).

a. Remove the lift ring or plug.

b. Insert magnet holder and magnet into the top of

the motor shaft using the magnet installation

tool.

c. Install the linear sensor assembly into the top

plate of the air motor.

6. Install the reed switch assembly (19).

a. Remove the air line to the motor.

b. Adjust the air fitting to make room for the reed

switch (19).

c. Install the reed switch into the air valve as

shown in F

IG. 41, and secure with the screw

(20).

FIG. 70: Install Air Valve Assembly

FIG. 71: Install Fitting

Screw

Slider Valve

O-ring

r_262374_3A0294_68a

Label

Fitting

r_262374_3A0294_69a

FIG. 72: Install Linear Sensor

ti18237a

Magnet

Holder

Motor

Shaft