User's Manual

Installation

32 3A0294G

e. Place the o-ring (20) on the lift ring adapter (19),

and apply the supplied adhesive to the threads.

See F

IG. 57.

f. Route the linear sensor cable through the lift

ring adapter. Install the lift ring adapter; torque

to 30-36 ft-lbs (40.6-48.8 N•m). See F

IG. 57.

g. Route the linear sensor cable through the hole

on the lift ring adapter.

h. Apply the supplied adhesive to the lift ring

threads. Install the lift ring; torque to 30-36 ft-lbs

(40.6-48.8 N•m). See F

IG. 57.

i. Remove the screw on the valve cover to remove

the cover. See F

IG. 58.

j. Install the reed switch sensor (22). Secure with

the 1 in. (25 mm) screw (24) and o-ring (23) pro-

vided. See F

IG. 58.

k. Connect the strain relief guide (26) to the reed

switch sensor. Use a wrench to tighten the 1/2

in. screw (25) on the strain relief guide and to

secure it to the top plate of the air motor.

l. Use a zip tie to secure the reed switch sensor

cable.

m. Reinstall the valve cover, and tighten the nut.

See F

IG. 58.

n. Remove round plug and route the linear sensor

cable through the opening in the back of the

cover. Snap the air motor cover back into place.

FIG. 57: Install Linear Sensor

Lift Ring

r_262373_3A0294_after_linear

FIG. 58: Install Reed Switch Sensor

FIG. 59: Install Strain Relief Guide

Screw

Cover