User's Manual

Installation

26 3A0294G

8. Install the linear sensor (17).

a. Remove the lift ring or plug.

b. Insert magnet and magnet holder into the top of

the motor shaft using the magnet installation

tool.

c. Install the linear sensor assembly into the top

plate of the air motor.

9. Install the reed switch assembly (20).

a. Remove the air line to the motor.

b. Adjust the air fitting to make room for the reed

switch (20).

c. Install the reed switch (20) into the air valve as

shown in F

IG. 41, and secure with the screw

(21).

NOTE: For air motor models M07xxx, M12xxx, and

M18xxx, which have the large mufflers, remove the muf-

fler before installing the reed switch. Reinstall the muf-

fler after the reed switch in installed.

10. Install the pressure sensor on the pump bleed port.

a. Use a wrench to remove the pressure valve.

b. Apply the supplied sealant to the adapter (30),

the manifold (31), and the pressure valve. Install

all three in the order listed. See F

IG. 43.

c. Disconnect pressure sensor at PT1.

FIG. 40: Install Linear Sensor

ti18237a

Magnet

Holder

Motor

Shaft

FIG. 41: Install Reed Switch

FIG. 42: Remove Pressure Valve

r_262374_3A0294_71a

Muffler

Pressure Valve

r_262370_3A0294_19a