User's Manual

Installation
18 3A0294G
c. Loosely install the air valve assembly (3).
Grease the o-ring included with the air valve
assembly. Install the o-ring and then finish
installing the air valve assembly. Secure with
screw.
d. Install the new air motor slider valve label that is
included with the air valve assembly. See F
IG.
15.
e. Coat the gauge fitting with PTFE tape, and then
reinstall. Use a wrench to tighten. See F
IG. 15.
f. Coat the swivel fitting (32) with PTFE tape.
Install the fitting and air hose on the back of the
new air valve assembly. Use two wrenches to
tighten.
7. Install the linear sensor assembly (18) and the reed
switch sensor (22).
a. D200 systems only: disconnect the air motor.
Loosen nut below crossbar. Use wrench to hold
thread adapter in place and loosen threaded rod
above crossbar with another wrench.
b. Remove the air motor top cover using a flat
head screwdriver.
FIG. 16: Install Air Valve Assembly
FIG. 17: Install Swivel Fitting
3
O-ring
Screw
r_262370_3A0294_11a
Slider Valve
Label
32
FIG. 18: Disconnect Air Motor
FIG. 19: Remove Air Motor Cover
Nut
Lift Ring
Adapter
Rod
ti10649a
Lift Ring
Plate
Thread
Adapter
ti8218b