User's Manual

Accessory Parts
3A0260H 79
Dynamic Regulator Installation
The dynamic regulator kit is used to control the static
pressure of a Therm-O-Flow. The PGM has a maximum
inlet pressure of 1500 psi. During dispense the dynamic
regulator kit will activate the normal regulator located on
the front panel of the Therm-O-Flow. When the system
is idle the secondary regulator will control static pres-
sure.
F
IG. 39
Detail A
3
1
6
2
4
11/16 in
.
7/32 in.
5
diameter
7
8
Remove plug and attach supplied tubing to
regulator inlet.
Holes required for mounting. See detail A.
5/32 in. tubing removed from Therm-O-Flow
regulator to be attached here.
Regulator pilot port will have an existing 5/32 in.
air line. This air line and its fitting are to be
removed from the regulator and replaced with
the fitting supplied with dynamic regulator.
The existing pilot tube will be connected to the
5/32 fitting on the diverting valve supplied with
24E575.
To Therm-O-Flow regulator pilot port.
Regulator inlet.
Thread existing air line with 1/2 in. npt coupling
to 90° swivel fitting.
Attach to PGM control panel.
1
2
3
4
5
6
7
8
5/16 in.