User's Manual

System Setup
22 3A0260H
Configure Errors
Set the error type (error or deviation) that will be issued
if the pressure or drive torque goes outside the set high
and/or low limits. See Appendix A - User Interface
Display on page 81 for information on the purpose of
each error type.
NOTE: When an alarm is set to Error the machine
will be disabled when the alarm occurs.
1. With the system in setup mode, press to navi-
gate to the Errors screen.
2. Press the Error Reset drop-down list and select
Enable or Disable.
3. Press the Inlet Pressure drop-down list and select
Error or Deviation.
4. Press the Outlet Pressure drop-down list and select
Error or Deviation.
5. Press the Drive Torque drop-down list and select
Error or Deviation.
F
IG. 15