User's Manual

Installation

14 3A0260H

Install Control Center

Mount

Ensure the following criteria are met before mounting

the PGM control center:

• Select a location for the control center that allows

adequate space for installation, service, and use of

the equipment.

• For best viewing, the user interface should be

60-64 in. (152-163 cm) from the floor.

• Ensure there is sufficient clearance around the con-

trol unit to run cables to other components.

• Ensure there is easy access to an appropriate elec-

trical power source. The National Electric Code

requires 3 ft. (0.91 m) of open space in front of the

control center.

• Ensure there is easy access to the power switch.

• Ensure the mounting surface can support the weight

of the control center and the cables attached to it.

Secure the control center with appropriate size bolts

through the 0.50 in. (13 mm) diameter holes. See the

mounting dimensions in the following table and F

IG. 5.

Control Center Assembly Measurement

24.0 in. (610 mm)

22.5 in. (572 mm)

30.0 in. (762 mm)

28.5 in. (724 mm)

IG. 5: Control Center Dimensions