User's Manual

Repair

28 3A0238P

5. Disconnect heat exchanger inlet hose (76) and fit-

ting from elbow fitting (249) on hydraulic housing

(206). Disconnect heat exchanger outlet hose (77)

and fitting from elbow fitting (248).

6. Remove the two bolts from (258) from the fluid

housing (206) and replace each with a 5/16-18

thread eye bolt. Install a third 5/16-18 eye-bolt as

indicated.

7. Run a rope through the three eye-bolts and between

the motor and the accumulator. Secure to a hydrau-

lic lift.

8. Remove the four bolts (57) and washers (56) secur-

ing the tank to the stand.

9. Lift the hydraulic power pack (55) and place on a

sturdy location capable of supporting up to 300 lbs

(136 kg).

FIG. 23:Heat Exchanger Inlet and Outlet Hoses

FIG.24

206

249

248

206 258

258

Install third eye-bolt here

FIG.25

To prevent serious injury from the hydraulic power

pack falling, ensure that the hydraulic power pack is

secured to the hydraulic lift before removing from the

stand.

56, 57