User's Manual

Overview
4 3A0006D
Overview
Required System Components
NOTE: The following components must be installed in
every ACS system.
24J305 Sensor Circuit Kit for E-Flo Pump
(Series D and later)
Verify that the 24J305 Sensor Circuit Kit is installed on
your E-Flo Pump. If the pump does not have the sensor
circuit, order Part No. 24J305. The kit contains the cir-
cuit board and TDC, position, and pressure sensors
necessary to utilize the Graco ACS module, taking
advantage of flow control and pressure control mode
delivered by Graco ACS software. See manual 311603.
For E-Flo Pumps Series C and earlier, check with
your local Graco Distributor for compatibility.
16D612 Power Module Assembly
Transforms AC power to a 24 Vdc power supply for the
pump sensor circuit. See manual 311608. This assem-
bly includes the following required power supply and
barriers, which are also available separately:
121314 Power Supply (required)
24 Vdc, 2 A. DIN rail mount.
16A630 TDC and Position Sensor Barrier
(2 channel) [required]
16A633 Transducer Barrier (1 channel) [required]
CAT5 Ethernet Cables
121994, 1 ft (0.305 m)
121998, 25 ft (7.6 m)
121999, 50 ft (15.2 m)
15V842, 100 ft (30.5 m)
15V843, 200 ft (61.0 m)
Optional Components
Optional ACS components can be ordered through your
Graco Distributor.
15V342 Ethernet Switch
Enables connection of ACS module to multiple network
components through an Ethernet.
Local I/O Box
120373 (UL/CSA)
120991 (ATEX)
Allows the operator to control the E-Flo locally at the
pump when performing maintenance or troubleshooting.
See page 12. Includes the following features:
• secure disable switch
• start/stop switch
• fault reset
TI15662a
TI15663a
TI15660a