User's Manual

ACS Software Update

32 3A0006D

ACS Software Update

This process is required to load files to the Graco ACS

module for an upgrade of the ACS application software.

The process allows update of application software

through the Ethernet port.

It is critical that the directions be followed in the correct

order and with detail.

Required data and equipment:

• The Graco Firmware file will be loaded through the

web browser. It will be 16J859G.CO5 (or a file of

this format with a xxx.CO5 extension of a later ver-

sion). This software is available at www.graco.com.

• Any PC/Laptop with an Ethernet port, and Mozilla

Firefox web browser program preloaded (version

3.0 or higher). Use only Mozilla Firefox. Internet

Explorer (IE) will not work properly.

1. Connect the ACS module Ethernet port to the

PC/Laptop using an Ethernet cable.

NOTE: Some laptops will allow connections with or with-

out a crossover cable. A standard Ethernet patch cord

should work, but a crossover cable may be required

depending on how your PC/Laptop is wired.

2. Set the Static IP Address on the PC/Laptop. Ensure

the PC/Laptop network settings are configured for a

static IP Address. The PC/Laptop should be set to

the same network settings as the ACS module. The

default ACS module IP is 192.168.1.5. Therefore

set the static IP of the PC/Laptop to 192.168.1.XXX

where XXX = 200 as an example. See F

. 31.

. 31. Setting the Static IP Address on a PC or Laptop