User's Manual

Operation

28 3A0006D

Calibrate the Transducer

NOTE: Only a 4-20 mA output transducer can be used

with the ACS.

NOTE: Calibration values for a Graco transducer are

listed on the label attached to the pump gearbox circuit

board cover. See F

. 23. For a non-Graco transducer,

refer to the manufacturer’s label or data sheet.

Enter the transducer calibration values where shown in

. 24, using the button to raise or lower the set-

point, as desired.

After the values are entered, the ACS will perform the

calibration.

Set the Clock

On the Configuration screen, click on

to access the clock screen

(see F

. 25). There are two methods to set the clock:

• To input the values yourself, use the buttons.

Click on to enter.

• To synchronize the ACS clock with your PC, click on

. All values will be

loaded from the PC and the window will close.

. 23. Calibration Label Location

. 24. Calibration Values

ti17606a

. 25. Set the Clock