User's Manual

Operation

3A0006D 27

Select System Features

See F

. 21.

Auto Decrement

Auto Decrement helps extend pump life by operating the

pump at the lowest speed necessary to maintain the

selected pressure range. Auto Decrement is operable in

pressure mode only. It reduces the flow rate incremen-

tally by 1 Hz every 1 second until the Run Flow Setpoint

is reached while still maintaining target pressure.

Auxiliary Relay On

Enables peripherals such as a back pressure regulator.

Cam Mode

Enables the Cam profile. If turned off, pressure mode is

disabled.

Sensor Fault Override

Check this box to allow the pump to continue to run if

the TDC or Position sensors fail. The pump will run in

flow mode.

Transducer Fault Override

Under normal operation, the ACS will shut down the

pump if the transducer fails. Selecting Transducer Fault

Override bypasses that safeguard and allows the pump

to continue to run. This selection cannot be made on

this screen; it can only be selected through Modbus.

Pressure Transducer Enable

Check this box if a pressure transducer is monitoring the

pressure. This is automatically enabled if Pressure is

selected as the Control Mode (see page 26).

Run and Sleep Setpoints

Check the Sleep Enable box to turn on the Sleep mode.

Sleep mode will remain on until it is turned off.

Click on the button to raise or lower the setpoints, as

desired. These values are expressed in gpm or lpm.

There are two setpoint fields:

• Run Setpoint sets the rate of the pump when it exits

Sleep mode and enters Run mode.

• Sleep Setpoint sets the rate of the pump during

Sleep mode.

. 21. System Features Menu

. 22. Sleep Settings