User's Manual

Installation
3A0006D 11
Location
Install the ACS Module and components in a non-haz-
ardous area.
Mounting
See Dimensions, page 43.
The ACS Module and associated components are
designed to be mounted on a DIN rail inside of the motor
control enclosure.
The ACS Module DIN rail bracket may be reversed if
desired, to accommodate installation requirements.
Remove the screws, turn the bracket 180°, and reat-
tach.
Ground the ACS Control Module
This equipment is not for use in explosive
atmospheres. Do not install equipment approved
only for non-hazardous location in a hazardous area.
The equipment must be grounded. Grounding
reduces the risk of static and electric shock by
providing an escape wire for the electrical current
due to static build up or in the event of a short circuit.
Ground the ACS Module through a proper
connection to a power source.
DIN rail bracket may be
reversed if desired.
ti17553a