Instructions-Parts Merkur ES Hopper Kit 334011B Material supply for Merkur ES spray packages. This manual contains kit installation instructions only. Important Safety Instructions Read all warnings and instructions in this manual and in your Merkur ES Spray Package manual. Save all instructions. 17A493, 2 Liter Hopper PROVEN QUALITY. LEADING TECHNOLOGY.
Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this manual where applicable.
Warnings WARNING EQUIPMENT MISUSE HAZARD • Misuse can cause death or serious injury. • Do not operate the unit when fatigued or under the influence of drugs or alcohol. • Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all equipment manuals. Read fluid and solvent manufacturer’s warnings. For complete information about your material, request MSDS from distributor or retailer. • Do not leave the work area while equipment is energized or under pressure.
Installation Installation Wall Packages 1. Install bracket to the side of the existing air motor bracket. Secure using bolts (6), washers (9), and nuts (10). 2. Slip bracket holes over bolt heads and slide into place. 3. Tighten bolts. 4. Grease adapter o-ring (11). 5. Install pump hose fitting (2b) into the lower and tighten the jam nut (2c) 6. Open clamp (4) around hopper outlet. 7. Use 7/8” hex on outlet hose fitting (2a) to rotate the hose in the hopper (1) for optimal fit in the bracket (8). 8.
Parts Parts Hopper Kit 17A493 Parts Ref No. 1 2 3 4 5* 6 7� 8 9 10 11 � 12 � Description HOPPER, 2L HOSE, Low Pressure Suction Hose COVER CLAMP, Quick Release SCREEN, SST 30 Mesh SCREW, 1/4”-20x5/8” O-RING BRACKET WASHER NUT O-RING LABEL, warning Qty. 1 1 1 1 1 2 1 2 2 2 1 1 * These parts are included in kit 17B207 (pack of 5) � These parts are included in repair kit 17B208 Replacement Danger and Warning labels, tags, and cards are available at no cost. Order part number 17A366.
Graco Information For the latest information about Graco products, visit www.graco.com. For patent information, see www.graco.com/patents. To place an order, contact your Graco Distributor or call to identify the nearest distributor. Phone: 612-623-6921 or Toll Free: 1-800-328-0211 Fax: 612-378-3505 All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice.
