User's Manual

Installation

333391B 9

System Configuration and

Wiring

If the product is permanently connected, it must be con-

nected to a grounded power source.

If an attachment plug is required in the end use

application:

• it must be rated for the product electrical specifica-

tions.

• it must be an approved, 3-wire grounding type

attachment plug.

• it must be plugged into an outlet that is properly

installed and grounded in accordance with all local

codes and ordinances.

Connecting Power Supply

1. To secure power supply to DIN rail, hook clips on

power supply (16) into DIN rail (7) (F

IG. 12). Push

down firmly on lower edge of power supply until you

hear a click.

2. Gently pull up on the bottom edge of the power sup-

ply (16) to verify it is securely in place.

3. Connect wiring harness (6) (F

IG. 13) to AC input ter-

minals on power supply (16).

• Black wire - line (L)

• White wire - neutral (N)

• Green/yellow wire - ground / earth

Dyna-Star Pump and Controller

Connections

1. Remove 2 to 3 inches of the outer insulation (h)

from bare end of the cable as shown F

IG. 14.

2. Strip each wire (j) as shown in FIG. 15.

Improper installation may result in a risk of electric

shock. All electric wiring must be done by a qualified

electrician and comply with all local codes and regula-

tions.

FIG. 12

FIG. 13

FIG. 14

FIG. 15