User's Manual

Installation

12 333391B

Installing Power Cord

1. Verify power at the main power source is discon-

nected and that the correct amperage circuit

breaker for the input voltage is installed.

2. Hard wire or install a plug to the bare end of power

cord (13). Be sure to connect wires to the correct

polarity:

• Brown wire - line (L)

• Blue wire - neutral (N)

• Green/yellow wire - ground / earth

3. Verify power switch (3) is in the OFF position.

4. Plug power cord plug (13) into connector (3a)

located below switch (3).

5. Connect power at main power source.

6. Turn power switch to ON as shown in F

IG. 25.

FIG. 25