User's Manual

Installation

333391B 11

plug (13) into the connector (3a) located below the

switch (3).

3. Position clamp around the cord near the plug and

mounting clamp installation hole (b).

NOTE: The clamp (25) should be installed close enough

to the power cord plug end to prevent the plug from

loosening itself from the connector (3a) when pulled;

resulting in an interruption or loss of power to the con-

troller. See F

IG. 22.

4. Unplug the power cord plug (13) from connector

(3a) (F

IG. 22).

5. Insert screw (24) through the two silver tabs (25a)

on the cord clamp (F

IG. 23). Then install screw

through the installation hole in the enclosure.

6. Install nut (23) over end of screw (24) on the inside

of the Enclosure (1) (F

IG. 24). Use two wrenches

(one on the nut and one on the screw head) to

securely tighten nut and power cord clamp (25) to

the Enclosure (1).

FIG. 21

FIG. 22

FIG. 23

FIG. 24

25a

Outside of Enclosure

Inside of Enclosure

Wrench on Nut (23)

Wrench on Screw (24)