User's Manual

Smart Control Operation

28 333388B Operation

Layout Mode

Layout Mode is used to calculate and mark parking lot

stalls.

1. Use to select Layout Mode.

2. Press and release gun trigger control and move

striper forward.

3. Striper default is to place a dot every 9.0 ft (2.7m) to

mark the stall size. Stall size is adjustable.

4. Dots are laid down until gun trigger control is pressed

and released again.

NOTE: An indicator before and after Layout Mode on

the screen alternately flash when gun trigger control is

pressed to signal mode is active.

Ref. Description

1 Opens Stall Calculator Menu.

See Stall Calculator, page 29.

2 Opens Angle Calculator Menu.

See Angle Calculator, page 30.

3 Distance between dots laid by striper

4 Adjust stall size/dot spacing width.

5 Adjust dot size.

1 2

ti23820a

ti18564b