User's Manual

Smart Control Operation
26 333388B Operation
Striping Mode
Operating in Striping Mode
Striper must be running and clutch engaged before acti-
vating gun trigger control.
1. Make sure engine is running and clutch switch is
engaged.
2. Use gun selector switches to select guns and line
type.
3. Activate gun trigger control to began spraying.
NOTE: In Automatic Mode the striper has a low speed
shutoff value of 0.6 MPH (1.0 kilometer/hour). The low
speed shutoff value can be adjusted or disabled. See
Data/Information, page 32.
NOTE: In Automatic Mode the will flash when gun
trigger control is pressed to signal mode is active.
1
12
5
6
7
8
9
34
2
3
ti23819a
Ref. Description
1
Select a “Favorite”, press for less than one sec-
ond.
Save a “Favorite”, press and hold for more than
three seconds.
2
Cycles between Manual or Automatic Mode.
Manual Mode: Press and hold gun trigger control
to stripe.
Automatic Mode: Press and release gun trigger
control to start striping. Press and release button
again to stop.
3 Line width button for MIL (thickness) calculation.
4 Resets “Job” values to zero.
5 Total line length sprayed.
6 Paint and Space length adjustment buttons.
7 Paint and Space distance that is sprayed if a
switch is set to skip line.
8 MIL thickness. While spraying “Instant MIL avg” is
displayed. When stopped total “Job MIL avg” is
displayed.
9 Five skip line favorites
Ref. Description
1 Exits and returns to the Striping Mode Menu.
2 Select switch 1, 2, or 3.
3 Line Width Adjustment, if switch is operating more
than one gun add the line widths together.