User's Manual

Setup M ode Scree

Stall Test Pressure

Set the minimum stall test pressure. The setting

should be approximately 50 psi (0.35 MPa, 3.5 bar)

higher than the highest inlet pressure.

Pump Stall Test

Set the duration for the pump stall test. See

Calibrate Screen 1, page 51.

Maximum Leak Rate

Enter the maximum allowable leak rate for a pump

stall test.

Mix Fill Set Point

Set a higher pressure for use while mix ﬁlling.

This higher pressure decreases the time needed

to ﬁll the gun. Once the gun is ﬁlled, the system

uses the recipe’s target pressure setpoint (set on

Recipe Screen, page 45)formixing.

The default v

alue is 0. When set to 0, the system

ignores the M

ix Fill Set Point and instead uses the

Non-Mix Pres

sure (set on System Screen 1, page 39)

while mix ﬁl

ling.

332562B