User's Manual

Run Mode Screens
Fill Screen
The Fill screen displays the following information for
the pump assigned to the current color:
• Material. Se
lect Color (A), Catalyst (B), or Solvent.
The pump anim
ation at the top of the screen will
show the sele
cted material. If solvent is selected,
enter the pum
pnumberintheboxtotheright.
• Flush Line (
only for systems with color change).
Select this
box if you want to flush the specified
material li
ne with solvent. The system uses flush
sequence 1.
To prime the pumps and fill the lines,firstread
Prime and Fill the System, page 25.
1. Press the Edit softkey
to open the screen
for editing.
2. Select Color (A).
3. Enter the color number in the box to the right.
4. If the selected material is not already loaded,
press the Prime softkey
. The system will
prime Color (A) into the selected pump through
the selected color valve and out the outlet dump
valve.
5. Press the Fill softkey
. The system will
attempt to fill the Color (A) lines until the user
presses Stop
. Trigger the gun into a waste
container.
6. Repeat for Catalyst (B).
To fl
ush the system (pump and fluid lines), see
Flu
sh the System, page 28.
To flush only the pump:
1. Press the Edit softkey
to open the screen
for editing.
2. Select Solvent.
3. Enter the pump number in the box to the right.
4. Press the Prime softkey
. The system will
flush solvent through the selected pump and out
thedumpvalve.
Figure 20 Fill Screen, Color (A) Selected
Figur
e 21 Fill Screen, Solvent Selected
332562B 35