User's Manual

Operation
Spraying
To spray in a multiple color system, also see
Multiple Color Systems, page 60.
NOTE: See Run
Mode Screens, page 31, for further
screen infor
mation, if needed.
1. Set the desi
red mix manifold to the SPRAY
position.
2. Press Mix
. The system will load the
correct mixed material volume. The Mix Mode
LED and the recipe display on the booth control
will blink during the mix fill. If the gun is loaded
with one recipe (G-xx) and the pumps with
another (P-xx), the display will alternate between
the two recipes. When the mix fill is completed,
the display will show R-xx, and the system will
go into Standby Mode.
NOTE: The system will automatically run a Mix
Fill if the recipe is not currently loaded into the
system. The Mix Fill volume calculation includes
the mix manifold volume and the mixed material
hose volume. The mixed material hose volume is
determined by the gun hose length and diameter
entered in System Screen 2, page 40.
3. Press Mix
again. The Mix Mode
LED will turn on solid to indicate the system is
mixing. Adjust the flow rate by changing the
target pressure. The fluid flow rate shown on the
Spray screen is the combined total of component
A and B out of the gun.
• If the fluid fl
ow rate is too low: increase the
spray press
ure setting on the Spray screen or
booth contr
ol.
• If the fluid
flow rate is too high: decrease the
spray pres
sure setting on the Spray screen or
booth cont
rol.
NOTE: If sp
ray pressure is adjusted at the ADM
or booth co
ntrol while spraying, it is not saved in
the recip
e until the system is put in Standby. This
changes t
he pressure in the desired recipe.
4. Turn on at
omizing air to the gun. Check the spray
pattern a
s instructed in your spray gun manual.
NOTE: Do not use the first 4-5 oz. (120-150 cc)
of material as it may not be thoroughly mixed due
to errors while priming the system. The Spray LED
must be on.
NOTICE
Do not allow a fluid supply tank to run empty.
This can damage the pumps and lead to the
proportioning of fluid and air that meets the ratio
and tolerance settings of the equipment. This can
further result in spraying uncatalyzed or poorly
catalyzed material.
26 332562B