User's Manual

Glossary of Term
s
Glossary of Te
rms
Advanced Display Module (ADM) -the
user interface for the system. See
Advanced Display Module, page 16.
Enhanced Flu
id Control Module (EFCM) -thefluid
controller f
or the system.
Grand Total - a non-resettable value that shows
the total amount of material dispensed through the
system.
Idle - if the gun is not triggered for a user-settable
value, the system enters Idle mode. Trigger the gun
to resume operation.
Intrinsic
ally Safe (IS) - refers to the ability to locate
certain co
mponents in a hazardous location.
Job Total - a resettable value that shows the amount
of material dispensed through the system for one job.
A job is complete when the user presses the Job
Complete key on the Booth Control or ADM.
Mix - when cross-linking of the resin (A) and catalyst
(B) occurs.
Potlife Time - the amount of time before a material
becomes unsprayable.
Potlife Volume - the amount of material that is
required to move through the mix manifold, hose, and
applicator before the potlife timer is reset.
Pump Calibration Factor - the amount of material
dispensed per revolution of the motor.
Purge - when all mixed material is flushed from the
mix manifold, hose, and gun.
Purge Time - the amount of time required to flush all
mixed material from the gun.
Run Screens - The Run screens provide a graphical
depiction of system operation and current status.
See RunModeScreens,page31.
Setup Screens - The Setup screens allow the
user to define the system, setup recipes, and
establish system operating parameters. See
Setup Mode Screens, page 38.
Standby - refers to the status of the system.
1
2
332562B