User's Manual

Installation
332540E 7
Installation
Pressure Relief
Follow the Pressure Relief Procedure whenever
you see this symbol.
To relieve pressure in the system, use two wrenches
working in opposite directions on pump outlet fitting to
slowly loosen fitting only until fitting is loose and no
more lubricant or air is leaking from fitting as shown in
F
IG. 3.
• Read and follow instructions supplied with each sys-
tem component.
• Reference letters used in the following Installation
instructions, refer to Typical Installation Key, page
5.
Wiring
Grounding
System Configuration and Wiring
NOTE: Cable wiring harness kits are available from
Graco. See Parts page 11 for a complete list of available
kits.
Fuses
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury
from pressurized fluid, such as skin injection,
splashing fluid and moving parts, follow the Pressure
Relief Procedure when you stop dispensing and
before cleaning, checking, or servicing the
equipment.
FIG. 3
COMPONENT RUPTURE HAZARD
The maximum working pressure of each component
in the system may not be the same. To reduce the
risk of overpressurizing any component in the sys-
tem, be sure you know the maximum working pres-
sure of each component. Never exceed the
maximum working pressure of the lowest rated com-
ponent in the system. Overpressurizing any compo-
nent can result in rupture, fire, explosion, property
damage and serious injury.
The equipment must be bonded (grounded) directly
to the truck. Grounding reduces the risk of static
shock due to static build up on the equipment.
NOTICE
Fuses (user supplied) are required on all models. To
avoid equipment damage:
• Never operate the Dyna-Star Pump models with-
out a fuse installed.
• A fuse of the correct voltage and amperage must
be installed in line with the power entry to the
system. Graco recommends using 35A fuses.