User's Manual

Installation

8 332518C

9. Securely fasten pump (A) to cover (e) using screws

securely.

10. Reinstall cover (b) using bolts (a). Use a wrench to

tighten bolts securely.

11. The Auto-Fill Shutoff Kit includes two supply

hoses/tubes (3 or 4 as shown on the cover.) Only

one hose/tube is used. Discard the hose/tube you

do not use.

• Supply tube (4) (marked with the 16V750 alumi-

num tag) and two connector fittings (5) are used

for manifold assemblies. Supply tube (3) can be

discarded. It is not used for a manifold installa-

tion.

a. Install connector fittings (5) to manifold inlet

(E) and Auto-Fill Shut Off outlet (D). Wrench

tighten each fitting (5) securely.

b. Install end of supply tube (4) to manifold inlet

(E) first and then install the other end of the

supply tube to the Auto-Fill Shut Off outlet (D)

and as shown in F

IG. 15.

HINT: For easier installation, loosen (but do not entirely

remove) screws (G) securing manifold (F) to pump. This

will allow the manifold to remain in a loosely mounted

state while installing the supply tube (4). After tube has

been installed securely, re-tighten manifold screws (G)

to secure manifold (F) to pump.

FIG. 13

FIG. 14

FIG. 15