User's Manual

Installation

10 332518C

14. Turn on remote filling station pump (K) and fill reser-

voir (F) until the indicator pin on the Auto-Fill Valve

(1) pushes up as shown in F

IG. 18; pressure in the

refill pump (K) builds and the pump stalls.

15. Turn off air supply to refill pump (K).

16. Relieve remote filling station pump pressure using

the following Remote Filling Station Pressure Relief

procedure:

Remote Filling Station Pressure Relief

The following Pressure Relief Procedure is only

used with the Auto-Fill Shut Off Valve to relieve

remote filling station and lubricant supply line

pressure.

a. To relieve pressure between the refill pump and

Auto-Fill Shut Off, open ball valve (bv) (F

IG. 19).

Pressure will be released and excess fluid will

drain out of the drain tube (dt) and into the lubri-

cation collection container (H).

b. Close ball valve (bv) when all pressure has

been relieved.

NOTE: The pin may not drop and the Auto-Fill

may not reset because the tank is full. However,

when the pump begins using the grease, the pin

resets. The pin must reset before the next cycle

of refilling.

17. Disconnect lubrication supply hose (L) from Auto-Fill

(1).

18. Install plug in Auto-Fill inlet or supply hose (L) inlet

to prevent contaminants from entering the pump.

FIG. 18

This equipment stays pressurized until pressure is

manually relieved. To help prevent serious injury from

pressurized fluid, such as skin injection, splashing

fluid and moving parts, follow the Pressure Relief

Procedure when you stop dispensing and before

cleaning, checking, or servicing the equipment.

FIG. 19: In line installation shown

FIG. 20

drops