User's Manual

Installation
4 332517B
9. Secure cover (1) to base (2) using washers (8) and
wing nuts (9) over the end of the base rod (2a) (F
IG.
4). Hand tighten wing nuts securely.
A
10. Position gasket (3) over hole (1b) in the center of
cover (1). Align holes (3a) in gasket (3) with holes in
the top of the cover (F
IG. 4).
11. Loosen bolts (b) and remove cover (c) from
Dyna-Star pump (F
IG. 2).
12. Install pump down tube (d) through hole (1b) in the
middle of cover (1), through hole in follower plate (if
used) and into bottom of bucket.
13. Replace screws (4) and washers (5) and wrench
tighten securely.
FIG. 4
FIG. 5
1b
3
3a
2a
8,9
c
b
FIG. 6
FIG. 7
1b
d
1
4
5