User's Manual

ManualsBrandsGraco ManualsAutomatic Lubrication SystemsGraco 332517B Dyna-Star HP or HF Pump 35# Pail and Follower Plate Kit

Instructions

Dyna-Star

HP or HF Pump

35# Pail Kit and Follower Plate

332517B

For adapting a 60# Dyna-Star Pump for use with a 35# bucket. For professional use only.

Part No.:

35# Pail Kit - 77X513

35# Follower Plate - 77X510

Important Safety Instructions

Read all warnings and instructions in this

manual and in the Dyna-Star HP or HF Pump

instruction manual. Save all instructions.

Summary of content (6 pages)

PAGE 1
Instructions Dyna-Star® HP or HF Pump 35# Pail Kit and Follower Plate 332517B For adapting a 60# Dyna-Star Pump for use with a 35# bucket. For professional use only. Important Safety Instructions Read all warnings and instructions in this manual and in the Dyna-Star HP or HF Pump instruction manual. Save all instructions. Part No.
PAGE 2
Warnings Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this manual where applicable.
PAGE 3
Installation Installation 7. Install cover (1) on top of bucket. The ends of base rods (2a) should pass through the holes (1a) in the cover brackets as shown in FIG. 2. Reference numbers used in the following instructions correspond to the Parts table provided on page 6. Parts identified with an alpha character are user provided or already installed components. 1 First Time Installation 1. Remove screws (4), washers (5) and gasket (3) from cover (1). Set these parts aside to use for reassembly. 2.
PAGE 4
Installation 9. Secure cover (1) to base (2) using washers (8) and wing nuts (9) over the end of the base rod (2a) (FIG. 4). Hand tighten wing nuts securely. 12. Install pump down tube (d) through hole (1b) in the middle of cover (1), through hole in follower plate (if used) and into bottom of bucket. A 1b 3a 8,9 3 d 2a 1b 1 FIG. 6 FIG. 4 10. Position gasket (3) over hole (1b) in the center of cover (1). Align holes (3a) in gasket (3) with holes in the top of the cover (FIG. 4). 13.
PAGE 5
Installation 14. Reinstall cover (c) using bolts (b). Use a wrench to tighten bolts securely. Changing Grease Bucket NOTE: The pump does not have to be removed from the cover to change the empty grease bucket. When grease bucket is empty: 1. Disconnect Dyna-Star pump from main power source. b c FIG. 8 2. Relieve pressure (see Pressure Relief procedure provided or in your pump manual). 15. Complete pump installation.
PAGE 6
Parts: 77X513 HEAVY EQUIPMENT HAZARD Lifting or moving heavy equipment incorrectly can cause serious injury. To avoid serious injuries, such as muscle strain or back injuries, when moving pump always use a lifting aid secured to the pump lift ring . See Technical Data, included in the pump instruction manual for pump weight information. 4. Remove cover and pump assembly from top of empty bucket (a). Ref.