User's Manual

Install the B ooth Control
Install the Booth Control
1. Use screws (S) to mount the bracket (10) for the
Booth Control (13) on the wall. Connect a ground
wire (G) to one of the screws. Connect the other
end of the ground wire to a true earth ground.
Figure 12 Ground the Booth Control Bracket
2. Snap the Booth Control into the bracket.
3. Connect the Booth Control to the Isolation Board
in the Electrical Control Box, using the 50 ft (15.2
m) intrinsically safe CAN cable (163).
NOTE: For a list of alternate cable lengths, see
Electrical Schematics, page 31. The total length
of cable used in the hazardous location must not
exceed 120 ft (36 m). The total length of all cable
used in the system must not exceed 150 ft (45 m).
Figure 13 Install the Booth Control
20 332457C