User's Manual

Install the Display Module

1. Use the screws (11) to mount the bracket (10) for

the Advanced Display Module (12) on the front of

the Control Box or on the wall, as you prefer.

2. Snap the Advanced Display Module into the

bracket.

Figure 10 Install Display Module

3. Connect one end of the 5 ft (1.5 m) CAN cable

(provided) to the Advanced Display Module

(M). The other end of the cable comes from the

factory connected to the Enhanced Fluid Control

Module (EFCM).

NOTE: For a list of alternate cable lengths, see

Electrical Schematics, page 31. The total length of

all cable used in the system must not exceed 150

ft (45 m).

Figure 11 Advanced Display Module Connection

Ports

Item Description

J Battery Cover

K Model Number

USB Drive Interface

CAN Cable Connection

ADM Status LEDs

P Accessory Cable

Connection

Token Access Cover

332457C 19