User's Manual
Installation
Installation
Before Installing the Kit
• Servicing the electrical control box exposes you
to high voltage. To avoid electric shock, turn off
power at the main circuit breaker before opening
the enclosure.
• All electrical wiring must be done by a qualified
electrician and comply with all local codes and
regulations.
• Do not substitute or modify system components
as this may impair intrinsic safety.
Follow the Pressure Relief Procedure in
your PD2K manual whenever you see this
symbol.
This equipment stays pressurized until pressure
is manually relieved. To help prevent serious
injury from pressurized fluid such as skin injection,
splashing fluid, and moving parts, follow the
Pressure Relief Procedure in your system manual
when you stop spraying and before cleaning,
checking, or servicing the equipment.
1. Flush the system as explained in your PD2K
Operation Manual. Follow the Pressure Relief
Procedure in your PD2K manual.
2. Close the main air shutoff valve on the air supply
line.
3. Remove electrical power from the system.
Install the Frame
1. Follow the steps in
Before Installing the Kit, page 8 .
2. Install the frame (13) to the upright of the PD2K
stand (A) using three screws (16) and nuts (18).
3. Install the back panel/bracket assembly (B) in the
outermost position on the frame (13), to allow
clearance for the color change manifold (C).
Fasten the panel to the frame (13) using four
screws (15) and nuts (18). Install the top screws
from the front and the bottom screws from the
back.
NOTE: The illustration shows a resin (70cc) pump
expansion kit being installed on the left (color) side
of the PD2K proportioner. The pump control module
and dual grommet (11) are preassembled at the
factory so the cable (8) is facing to the right, allowing
easier access to connections inside the PD2K
electrical control box (D).
Install a catalyst (35cc) pump expansion kit on the
right side of the proportioner, with the pump control
module and dual grommet (11) preassembled in the
opposite direction so the cable (8) is facing to the left.
8 332456B