User's Manual

Installation
Electrical Connections
NOTICE
To avoid electrical component damage, remove all
system power before plugging any connectors.
NOTE: See the Electrical Schematics, page 21.
1. Verify that electrical power is removed from the
system.
2. Remove the cover from the PD2K electrical
control box.
3. Remove the knockout (K) from the side of the
electrical control box.
4. Thread the cable into the electrical control box
and connect to the appropriate connection port
on the enhanced fluid control module (Pump 3 to
P3andPump4toP4).
Figure 6 Install Grommet in Electrical Control
Box
Figure 7 Enhanced Fluid Control Module
Connection Points
332456B 13