User's Manual

Secondary Bead Tank

4 332225D

7. Place clamping band around tank and secure with

mounting hardware shown below. Tighten both

tanks until there is no movement between clamps

and bead tanks. NOTE: The flats on the clamp are

not intended to touch when tank bracket is tight-

ened.

8. To install secondary regulator, remove 1/4 in. NPT

plug (F) from air tank assembly.

9. Apply thread sealant and install nipple fitting.

10. Use wrench to install second regulator assembly

(G) and position as shown below.

11. Install 36 in. nylon air line from top of second

regulator (G) to swivel fitting on top of second bead

tank. Push airline into each fitting as shown.

12. Position handle to best suit filling needs.

NOTE: Loosen bolt (H) to help swivel, then

re-tighten.

ti20554a

ti21259a

ti20550a

ti20549a

ti20704a