User's Manual

Startup

313997W 47

Startup

1. Use feed pumps to load fluid

NOTE:

The HFR is tested with oil at the factory. Flush out the oil

with a compatible solvent before dispensing. See Flush-

ing on page 52.

a. Check that all machine connections are setup.

See Setup procedure, page 38.

b. Check that inlet screens are clean before daily

startup, see page 56.

c. Check level and condition of ISO lube daily, see

IsoGuard Select

System on page 57.

d. Turn on component B (Blue) and component A

(Red) agitators, if used.

e. Turn both PRESSURE RELIEF/DISPENSE

valves (SA, SB) to DISPENSE .

f. Start feed pumps.

g. Open fluid inlet valves (FV). Check for leaks.

h. Use feed pumps to load system.

i. For models with an EP, Fusion, or P2 gun

only, hold gun fluid manifold over two grounded

waste containers. Open gun fluid valves A (Red)

and B (Blue) until clean, air-free fluid comes

from valves. Close valves.

j. For models with an MD2 Valve only, hold

MD2 valve nose piece, without a mixer installed,

over two grounded waste containers. Leave

mixer off and trigger gun until both fluids flow

freely from the nose piece without any air.

k. To prime the pump, cycle the pump a few times

or until air-free fluid dispenses.

Do not operate HFR without all covers and shrouds in

place.

ti9877a1

Keep Components A (Red) and B (Blue) Separate

Cross-contamination can result in cured material in

fluid lines which could cause serious injury or damage

equipment. To prevent cross-contamination of the

equipment’s wetted parts, never interchange compo-

nent A (Red) and component B (Blue) parts.

ti10002a1

ti2484a1