User's Manual

Electrical

20 313881B

Electrical

Requirements

NOTE: All options ordered on the ProMix system are

electrically tested at the factory.

The ProMix operates with 85-250 VAC, 50/60 Hz input

power, with a maximum of 2 amp current draw. The

power supply circuit must be protected with a 15 amp

maximum circuit breaker.

Not included with system:

• Power supply cord compatible to your local power

configuration. Wire gauge size must be 8-14 AWG.

• The input power access port

is 22.4 mm

(0.88 in.) diameter. It accepts a bulkhead strain

relief fitting or conduit. See F

. 10.

Connect Main Power

1. Provide power to the Power Supply Module. Install a

bulkhead strain relief or conduit bulkhead through

the Power Supply Module port . See F

. 10.

2. See F

. 9 and the System Electrical Schematic

on page 36 for the L1, N, and ground wiring connec-

tions inside the Power Supply Module.

3. Ground the Power Supply Module to a true earth

ground. See Grounding, page 32.

• To avoid electric shock, turn off EasyKey power

before servicing.

• Servicing EasyKey exposes you to high voltage.

Shut off power at main circuit breaker before open-

ing enclosure.

• All electrical wiring must be completed by a quali-

fied electrician and comply with all local codes and

regulations.

• Enclose all cables routed in the spray booth and

high traffic areas in conduit to prevent damage

from paint, solvent, and traffic.

. 9. Main Power Connection

TI14368a

Input Power

Terminal Block