User's Manual

Operation
313875J 43
Dispensing
Dispense in Shot Mode
To dispense in Shot mode, at least one shot number
must be defined. Shots are defined on the Shots
screen, see page 59.
1. Navigate to the Home screen.
2. Press repeatedly to select Shot Mode then
press to accept.
3. If desired, change the selected shot.
a. Press .
b. Use numeric keypad to type the desired shot
number.
c. Press to accept. The shot number defini-
tion details will be shown on the bottom of the
screen.
NOTE: Only defined shot numbers can be entered. If an
undefined shot number is entered, it will be ignored.
4. Press to begin dispensing the active shot. To
abort the shot at any time, press or . The
shot will continue until the predefined amount has
been dispensed.
5. Check the ADM for errors and pop-up notifications
that could indicate a faulty dispense. Press to
acknowledge any displayed errors.
Dispense in Sequence Mode
Sequences can be defined on the Sequences screen.
Sequences are defined on the Sequences screen, see
page 60.
1. Navigate to the Home screen.
2. Press repeatedly to select Sequence Mode
then press to accept.
3. If desired, changed the selected sequence.
a. Press once.
b. Press the right arrow key on the ADM keypad
once.
c. Use the up and down arrow keys to select a
sequence.
d. Press to accept.
4. If desired, press to skip to the next defined
shot position in the sequence. Repeat as desired.
To go to the first defined position in the sequence,
press .
5. Press to begin dispensing the active shot.
NOTE: To abort the shot at any time, press or
. If the shot is not aborted, material will continue to
dispense until the predefined amount has been dis-
pensed. The next position in the Sequence will automat-
ically be selected upon completion of the shot.
6. Check the ADM for errors and pop-up notifications
that could indicate a faulty dispense. Press to
acknowledge any displayed errors.