User's Manual

Setup

26 313875J

11.If applicable, attach and adjust

drum low/empty sensor.

NOTE: An optional kit can be purchased to indicate

either when the drum is low or when it is empty.

a. Position ram at desired level (low or empty).

b. Attach low/empty sensor bracket (A) to mount-

ing bracket (B).

c. Attach the actuator (D) to the ram piston rod,

near the top, so it passes in front of the

sensor (E) at the correct level for drum low or

drum empty.

12.Install material drums. See Install

Drum procedure, page 29.

13.Perform Startup procedure,

page 28.

14.Perform ADM setup.

NOTE: All ADM setup items are located in the Setup

screens. See Appendix B - ADM Setup Screens Over-

view beginning on page 59 for more information.

See ADM Operation Overview on page 31 for help with

operating the ADM including how to modify settings.

a. Navigate to Advanced #1 screen then set gen-

eral system settings. See page 63.

b. Navigate to Advanced #2 screen then set units

of measure. See page 63.

c. Navigate to Advanced #3 screen then

enable/disable system features. See page 64.

d. Navigate to System #1 screen then define con-

trol mode, dispense mode, and pump informa-

tion. See page 61.

e. Navigate to System #2 screen then define dis-

pense valve details and other system settings.

See page 61.

f. Navigate to System #3 screen then define

labels, pressure imbalance, and flow meter

details. See page 62.

g. Navigate to Shots screen then define shots.

See page 59.

h. Navigate to Sequences screen then define

sequences. See page 60.

i. If desired, navigate to Maintenance screen

then reset counters. See page 62.

15.Perform System Setup and Cali-

bration procedure on page 34.

ti10916a