User's Manual

Repair
20 313874E
5. Apply a light coating of lubricant to seals of
tube (411). Install tube (411) onto elbow fitting (410)
and straight fitting (409). Hand-tighten then use
wrench to tighten 90 degrees further.
6. Install thrust washers (421) onto hex head cap
screws (422). Apply pipe sealant to threads of
screws. Align tank gasket (419), hydraulic housing,
and tank (420) then install screws. Torque to 15 ft-lb
(20 N•m).
7. Perform Install Hydraulic Power Pack procedure,
see page 18.
NOTICE
Do not over-torque any item that threads into the
hydraulic tank. This will strip the threads and
require tank replacement.