User's Manual

Repair
10 313874E
Repair
Linear Position Sensor Replacement
NOTE: See FIG. 1 for part references.
1. Perform Shutdown procedure. See operation man-
ual for procedure.
2. Remove pumpline shield.
3. Insert a large allen wrench through the center of the
lift ring (717) then twist to loosen. Remove lift ring.
4. Disconnect linear position sensor cable. Route the
cable through the hole in the plate (713) directly
above the linear position sensor (718).
5. Use a 1-1/4 in. wrench to loosen the linear position
sensor. Remove the linear position sensor.
6. Carefully insert the new linear position sensor
through the hole in the plate (713) and into the verti-
cal hydraulic driver. Use a 1-1/4 in. wrench to gently
tighten.
FIG.1
702
706
701
704
707
708
705
714
715
710
711
712
718
713
716
1
Torque to 100 ft-lb (135 N•m).
Torque to 350 in-lb (39.5 N•m).
Apply a light coating of lubricant to seals and
surfaces specified.
Torque to 50-60 ft-lb (68-81 N•m).
Apply adhesive to surfaces specified.
Torque to 10-12 in-lb (1.1-1.4 N•m).
Apply thread sealant to threads.
Torque to 30-36 ft-lb (41-49 N•m).
Orient ref 701 with date code on casting
opposite of 0.25 diameter hole as shown. Ref
704 to be on opposite side of 0.25 diameter
hole as shown.
1
2
3
4
5
6
7
8
9
9
3
6
5
4
4
4
ti17670a
722, 723
708
3
2
9