User's Manual

313759A 9

Nipple Installation Instructions

A M8x1 connection for fitting + sleeve

B Copper Washer

C M10 x 1 or M12 x 1 straight fitting for dosers

1. (If adding nipple to casting with red or white plug, or

replacing an existing nipple) Relieve pressure,

page 7.

2. Carefully remove cap.

NOTE: Due to spring located under cap, cap will be

under pressure.

3. Thread nipple into fitting. Torque to 13 to 17. 7 in-lbs

(1.46 to 1.99 N.m).

NOTE: For a #1 nipple only, piston must also be

removed. Then install piston from #1 nipple followed by

nipple. Torque to specification in step 3.

FIG. 4