User's Manual

Turbine Replacement
313406L 11
Turbine Replacement
Refer to Parts Drawing, page 14.
1. Follow Sprayer Disassembly procedure, page 10.
2. Remove gasket (21).
3. Remove three screws (14) from spacer (38).
4. Remove plate (21) and three spacers (83).
5. Remove motor wires from spade connectors.
6. Rotate motor (11) from outlet fitting (29) and lift up
from spacers (41).
7. Install new gaskets (21, 23, 24, 59 and 60). Use min-
eral spirits solvent (also called white spirit) to remove
any adhesive remaining from old gaskets.
8. Reassemble turbine. Use an adjustable square with
the blade running the full length of the longest side of
the duct (22) to position duct perpendicular to base
(2). Hold duct in place and carefully remove square to
keep duct perpendicular to edge of base. With
sprayer upside down, carefully slip base plate and
attached parts (see page 16) down into HVLP box
(1). NOTE: Be sure to maintain duct alignment.
9. Connect ground wire to motor housing.
10. Reconnect wires. Attach plug (61) to HVLP box with
two screws (101).