User's Manual

Operation

312878J 29

Operation

Startup

See hydraulic proportioner operation manual 312062.

Change Operating Mode

Operating modes Shot (“Sh”) and Manual (“Mn”) will

always be available and Sequence mode (“Sq-X”) will be

available when one or more sequences are created by

the user. See Setup Screen #3: Shot Sequences on

page 21. To change the operating mode, hit the Mode

Select key on the HMI until the desired operating mode

is shown in the top left corner of the screen. Hit the top

soft key to confirm the mode selection.

Change Shot Number

To change the selected shot from the idle run screen, hit

the up or down arrow keys. When the desired shot is

selected, hit the top soft key to confirm the selection.

Change Shot Volume/Weight

To change the defined shot volume or weight for the

selected shot, first enter Run Screen Shot Editing mode

by pressing and holding both the up and down arrow

keys for three seconds. Use the up and down arrow keys

to change the shot volume/weight then confirm the

change when prompted.

The AR Pour Gun and shot controller modify the

hydraulic proportioner to pour instead of spray but

all operation procedures from hydraulic proportioner

operation manual 312062 are applicable.

Only shots with non-zero volumes/weights can be

selected.

IG. 16: Run Screen Shot Editing, Changing Operating Mode

When

changing the operating mode or shot number, the item being changed will be

highlighted

During Run Screen Shot Editing, the shot quantity will be highlighted

A password may be required to edit this item

All changes must be confirmed or cancelled

2 3