User's Manual

Conversion Kit Installation
312878J 17
Disable Motor Standby
Operation
A shot delivered while the Reactor
™
electric motor and
hydraulic pump are ramping up to full speed may be
inaccurate. Because of this, it is recommended that
Motor Standby mode be disabled when the Shot Con-
troller is installed. See the Standby section in the Reac-
tor operation manual 312062 for information about
disabling Standby mode.
If the Reactor Standby mode has not been disabled and
the motor has entered Standby mode the machine can
be brought back to full pressure in one of two ways:
• Not recommended: Trigger a shot. The system will
sense the pressure drop and the motor will ramp up
to full speed. Shot may be inaccurate.
• Recommended: Press on the Motor Controls to
turn the motor circuit OFF, then press it again to turn
it back ON. This will cancel Standby mode and
restart the motor. Wait for the Reactor to regain full
pressure before triggering a shot.