User's Manual

Flow Control

312778D 27

Flow Control

The intrinsically safe flow regulator (FC) is required to

use flow control in your system.

1. Connect a 1/4 in. (6 mm) OD air supply line to the

air inlet fitting of the flow regulator (FC). Connect the

other end of this line as follows:

a. Wall Mount Systems: Connect to the air mani-

fold at the rear of the wall mount fluid station.

b. RoboMix Systems: Install a 1/4 in. (6 mm) OD

tube tee at the air logic inlet of the RoboMix.

Connect the flow control air line to one branch

of the tee and the main air line to the other

branch.

2. Connect a fluid inlet line from the static mixer tube at

the fluid station to the 1/8 npt(f) inlet of the flow reg-

ulator (FC).

3. Connect a fluid outlet line from the 1/8 npt(f) outlet

of the flow regulator (FC) to the spray gun inlet.

4. Connect the flow control cable to J5 on the fluid sta-

tion control board and to the cable connector on the

flow regulator (FC).

. 16. Flow Control Regulator

TI13656a

Fluid Outlet to Gun

Fluid Inlet from

Fluid Station

Air Line from

Fluid Station

Cable from

Fluid Station