User's Manual

Component Identification and Definition
14 312778D
Table 1: Component Descriptions
Component Description
EasyKey (EK)
Used to set up, display, operate, and monitor the system. The EasyKey accepts 85-250
VAC, 50/60 Hz line power and converts that power to acceptable low voltage and optical
signals used by other system components.
Wall Mount Fluid
Station (ST, used on
ADxxxx and AExxxx
Models only)
Includes air control solenoids, flow switches, and mountings for the fluid flow meters, and
the fluid manifold assembly. Its control board manages all proportioning functions.
RoboMix Fluid
Station (ST, used on
RDxxxx and RExxxx
Models only)
Includes air control solenoids, flow switches, fluid flow meters, and the fluid manifold
assembly to control and monitor fluid dispensing. Its control board manages all propor-
tioning functions.
Fluid Manifold (FM)
• Pneumatically Operated Dose Valves for component A and B
• Purge Valves for solvent and air purge
• Sampling Valves for calibrating the flow meters and performing ratio checks (Wall
Mount Panel only)
• Shutoff Valves for component A and B to close their fluid passages to the mix mani-
fold, to allow for accurate calibration and ratio checks (Wall Mount Panel only)
• Mix Manifold, which includes the fluid integrator and static mixer.
➜ Fluid Integrator is the chamber where component A and B align at the
selected ratio and begin to mix.
➜ Static Mixer has 24 elements to uniformly blend the materials downstream
of the fluid integrator.